Low speed compression damping force
To increase the compression damping force
and thereby harden the low speed compres-
sion damping, turn the compression damping
force adjusting screw in direction (a). To de-
crease the compression damping force and
thereby soften the low speed compression
damping, turn the adjusting screw in direction
(b).
5
(b)
1
1. Low speed compression damping force adjusting screw
(a)
Low speed compression damping setting
Minimum (soft):
4 turn(s) out from the fully turned in posi-
tion
Standard:
2 turn(s) out from the fully turned in posi-
tion
Maximum (hard):
Adjusting screw fully turned in
EWB03500
WARNING
These shock absorber assemblies contain
highly pressurized nitrogen gas. Read and
understand the following information be-
fore handling the shock absorber assem-
blies.
Do not tamper with or attempt to open
the cylinder assemblies.
Do not subject the shock absorber as-
sembly to an open flame or other high
heat source. This may cause the unit to
explode due to excessive gas pressure.
5-47