Do not lower the Release Cam / Lock Bar if the Release Cam is in the Up
position, as shown below. The Release Cam needs to be in the Down position, as shown in the
figure on the previous page.
If the Release Cam is in the Up position, carefully use your hand to move it to the Down position.
Not to scale. Components shown. Release Cam shown in the Up position, which must be
changed to the Down position before lowering.
If one side re-engages on the Lock Block but the other does not, immediately release the Down
button, press, and hold Up, go further past the Lock Block, release Up, and then press and hold
the Down button . If this issue continues, refer to Troubleshooting.
Note:
Always press Down for ≈5 seconds after the Frames are on the ground; this ensures that
as much Hydraulic Fluid as possible returns to the Fluid Reservoir.
3. Remove the QuickJack Frames from underneath the Vehicle; you may want to use the Quick
Frame Handles.
4. Move the Vehicle, if desired.
⚠
CAUTION
QuickJack™ Portable Car Jack
Do not drive on the QuickJack Frames or Hydraulic Hoses.
45
P/N 5900263 — Rev. B6 —September 2023