QuickJack 3500SLX Setup And Operation Manual page 2

Manual. QuickJack™ Portable Car Jack, Setup and Operation Manual, P/N 5900263, Manual Revision B6, Released
September 2023.
Copyright. Copyright © 2023 by BendPak Inc. All rights reserved. You may make copies of this document if you agree that:
you will give full attribution to BendPak Inc., you will not make changes to the content, you do not gain any rights to this
content, and you will not use the copies for commercial purposes.
Trademarks. BendPak and the BendPak logo are registered trademarks of BendPak Inc. QuickJack and JackPak are
trademarks of BendPak Inc. All other company, product, and service names are used for identification only. All trademarks
and registered trademarks are the property of their respective owners.
Limitations. Every effort has been made to ensure complete and accurate instructions are included in this
manual. However, product updates, revisions, and/or changes may have occurred since this manual was
published. BendPak reserves the right to change any information in this manual without incurring any
obligation for equipment previously or subsequently sold. BendPak is not responsible for typographical
errors in this manual. The latest version of the manual for this product is
www.quickjack.com/support/downloads/
Warranty. The QuickJack warranty is more than a commitment to you: it is also a commitment to the value
of your new product. For full warranty details and to register your new QuickJack product, contact your nearest QuickJack
dealer or visit quickjack.com/warranty.
Safety. Your new product was designed and manufactured with safety in mind. Your safety also depends on proper training
and thoughtful operation. Do not set up, operate, maintain, or repair the unit without reading and understanding this manual
and the labels on the unit.
Owner Responsibility. In order to maintain your product properly and to ensure operator safety, it is the responsibility of
the product owner to read and follow these instructions:
• Follow all setup, operation, and maintenance instructions.
• Make sure product setup conforms to all applicable local, state, and federal codes, rules, and regulations, such as state
and federal OSHA regulations and electrical codes.
• Consult a qualified person or organization to address any special regional structural and/or seismic requirements
specified by any other agencies and/or codes. The QuickJack must be installed on a flat surface which can support the
load of the vehicle being lifted without subsidence or movement.
• Read and follow all safety instructions. Keep them readily available for operators.
• Make sure all operators are properly trained, know how to safely operate the unit, and are properly supervised.
• Do not operate the product until you are certain that all parts are in place and operating correctly.
• Carefully inspect the product on a regular basis and perform all maintenance as required.
• Service and maintain the unit only with approved replacement parts.
• Keep all instructions permanently with the product and make sure all labels are clean and visible.
Only use this product if it can be used safely!
Unit Information. Enter the Model Number, Serial
Number, and the Date of Manufacture from the label
on your unit. This information is required for part or warranty
issues.
Model:
Serial:
Date of Manufacture:
available on
or by scanning the QR code.