QuickJack 3500SLX Setup And Operation Manual page 16

Setup
Unpacking
3
Checklist
Open the boxes and arrange the QuickJack components where you will be setting them up.
The components needed to set up a QuickJack:
• Box 1. Includes the Left Frame.
• Box 2. Includes the Right Frame.
• Box 3. Includes the Power Unit (operating voltage chosen at time of purchase), Parts Bag,
Hydraulic Hoses, 4 Medium Lifting Blocks, and 4 Tall Lifting Blocks.
⚠
WARNING
⚠
CAUTION
QuickJack™ Portable Car Jack
Your two QuickJack Frames are similar, but they are not interchangeable. Always
line up the Frames parallel to each other as much as the Lifting Points will allow,
with the Lock Bars on the outside, as shown below.
Be sure to route the Short Hydraulic Hoses under the QuickJack Frames. If they
are routed over the QuickJack Frames, the QuickJack will not work correctly, and
the Hoses could be damaged.
16
P/N 5900263 — Rev. B6 —September 2023