York DC180 Installation Manual page 47

When the "Cancel" button is pressed multiple times to exit each menu level and the screen returns to the first "Status, Alarms" dis-
play the next demonstration can begin. In this demonstration the information below steps through the "Commissioning" menu.
Step 1- Beginning at the status/alarm screen toggle the joystick down three times. This accesses
the "Commissioning " screen. In this menu section various settings can be changed. Please see
>Status
Alarms
ENTER
CANCEL
JOY +
-
Step 3- After "ENTER"
is pressed the various
parameter sections
appear, such as: HVAC
zone, Indoor Fan, Clg,
Htg, Econ and others.
>HVAC Zone
Indoor Fan
ENTER
CANCEL
Step 6- By toggling down
twice the screen reaches
the "ClgOcc-SP" screen
or "Cooling Occupied Set
Point".
LeadLag-Engaged
>ClgOcc-SP
ENTER
CANCEL
JOY +
These few pages provide a simple demonstration how to navigate the menu's of the Simplicity SE control containing
Johnson Controls Unitary Products
Status
>Alarms
ENTER
CANCEL
JOY +
C PWR
Step 4- After toggling the
joystick down two times
"Clg" appears. This allows
items, such as lead-lag and
OCC/UNOCC cooling set
points, to be changed.
ENTER
CANCEL
JOY +
- C PWR
Step 7- After pressing "ENTER" at
the "ClgOCC-SP" screen the space
temperature set point appears. NOTE:
Only applies to units controlled by a
space sensor.
Press Enter
ENTER
CANCEL
- C PWR
Step 9- The joystick was toggled right
to increase the set point temperature.
change mode. Once the desired
set point/value is reached press the
""ENTER"" button to save the value.
Alarms
>Summary
ENTER
CANCEL
- C PWR
Indoor Fan
>Clg
Press Enter
JOY +
- C PWR
ClgOcc-SP
72 F
JOY +
- C PWR
ClgOcc-SP
95 F
ENTER
CANCEL
Step 2- Once commission
appears next to the cursor,
press "ENTER" to begin
viewing parameters.
Summary
>Commisn
ENTER
CANCEL
JOY +
- C PWR
Step 5- At the "Clg" screen
once "ENTER" is pushed the
status indicates if cooling
is engaged/disengaged
and lead-lag is engaged/
disengaged.
Clg-Engaged
LeadLag-Engaged
ENTER
CANCEL
JOY +
- C PWR
Step 8- In order to change set points push the
toggle switch left or right. Note: The screen
increases. In this demonstration the ClgOCC
setpoint is changed from 72F to 95F.
Toggle Left to Decrease
Toggle Right to Increase
Screen Will
Flash
DOWN UP
JOY +
- C PWR
5120416-XIM-C-0216
JOY +
- C PWR
47