Table of Contents
Advertisement
About this task
The following images indicate the location of the touchpad and provides a visual representation of the installation procedure.
Steps
1. Place the touchpad into its slot on the palmrest and keyboard assembly.
2. Align the screw holes on the touchpad to the screw holes on the palmrest and keyboard assembly.
3. Replace the two screws (M2x2) that secure the touchpad to the palmrest and keyboard assembly.
4. Connect the touchpad Flexible Flat cable to the connector on the system board and close the latch.
5. Place the touchpad bracket on the touchpad.
6. Align the screw holes on the touchpad bracket to the screw holes on the palmrest and keyboard assembly.
7. Replace the three screws (M2x2) that secure the touchpad bracket to the palmrest and keyboard assembly.
8. Connect the hard drive cable to the connector on the system board.
Next steps
1. Install the battery.
2. Install the
base
cover.
3. Install the
SD
card.
4. Follow the procedure in
After working inside your
computer.
Removing and installing components
69
Advertisement
Table of Contents
