Table of Contents
Advertisement
4. Remove the three transit bolts and pull
out the plastic spacers.
5. Put the plastic caps, that you find in the
user manual bag, in the holes.
We recommend that you keep the
packaging and the transit bolts for
any transport of the appliance.
5.2 Information for installation
Positioning and levelling
Adjust the appliance correctly to prevent
vibration, noise and movement of the
appliance when it operates.
1. Install the appliance on a flat hard floor.
The appliance must be levelled and stable.
Make sure that the appliance does not touch
the wall or other units and there is air
circulation below the appliance.
2. Loosen or tighten the feet to adjust the
level. All feet must rest firmly on the floor.
WARNING!
Do not put cardboard, wood or equivalent
materials below the appliance feet to
adjust the level.
The inlet hose
CAUTION!
Make sure there is no damage to hoses
and there are no leaks from the
couplings. Do not use an extension hose
if the inlet hose is too short. Contact the
service centre for a replacement inlet
hose.
1. Connect the water inlet hose to the back of
the appliance.
45º
45º
20º
20º
2. Position it toward left or right depending on
the positon of the water tap. Make sure that
the inlet hose is not in vertical position.
3. If necessary, loosen the ring nut to set it in
the correct position.
4. Connect the water inlet hose to the cold
water tap with 3/4'' thread.
WARNING!
The inlet water shall not exceed 25 °C.
Water drainage
The drain hose should stay at a height of no
less than 60 cm and not more than 100 cm.
You can extend the drain hose to
maximum 400 cm. Contact the
authorised service centre for the other
drain hose and the extension.
It is possible to connect the drain hose in
different ways:
ENGLISH
9
Advertisement
Table of Contents
