A-6
SAFETY PRECAUTIONS
Read this entire installation section before you
start installation.
WARNING
ELECTRIC SHOCK can kill.
• Only qualified personnel should per-
form this installation.
• Turn the input power OFF at the dis-
connect switch or fuse box before
working on this equipment. Turn off
the input power to any other equip-
ment connected to the welding sys-
tem at the disconnect switch or fuse
box before working on the equipment.
• Do not touch electrically hot parts.
------------------------------------------------------------------------
NON-STANDARD SAFETY INFORMATION
CAUTION
The MAXsa™ series of wire drives may be at
welding voltage potential when the output of the
power source is active.
------------------------------------------------------------------------
INPUT AND GROUND CONNECTIONS
Only a qualified electrician should connect the MAXsa™
29 WIRE DRIVE. Wire Drive Installation should be made
in accordance with the appropriate National Electrical
Code, all local codes and the information in this manual.
LOCATION AND MOUNTING
The MAXsa™ Wire Drive will operate in harsh indoor
environments. It has an IP2X rating.
This equipment is for industrial use only and it is not
intended for use in residential locations where the
electrical power is provided by the public low-voltage
supply system. There can be potential difficulties in
residential locations due to conducted as well as radi-
ated radio-frequency disturbances. The EMC or RF
classification of this equipment is Class A.
INSTALLATION
HIGH FREQUENCY PROTECTION
Locate the MAXsa™ Wire Driveaway from radio con-
trolled machinery.
MAXsa™ 29 WIRE DRIVE
A-6