Honda CRF250RLA Owner's Manual page 92

Tyre Puncture Removing Wheels
u
Installation
Attach the side collars to the wheel.
1.
On the right side, place the wheel
2.
between the fork legs and insert the front
axle shaft, through the right fork leg and
wheel hub.
Avoid scratching the brake pads,
u
carefully fit the brake disc between the
pads.
NOTICE
When installing a wheel or caliper into original
position, carefully fit the brake disc between the
pads to avoid scratching them.
Tighten the axle shaft.
3.
Torque: 69 N·m (7.0 kgf·m, 51 lbf·ft)
Lower the front wheel on the ground.
4.
Apply the brake lever several times. Then,
5.
pump the fork several times.
88
Tighten the axle pinch bolt.
6.
Torque: 22 N·m (2.2 kgf·m, 16 lbf·ft)
Raise the front wheel off the ground
7.
again, and check that the wheel rotates
freely after you release the brake.
Lower the front wheel on the ground
8.
again.
If a torque wrench was not used for
installation, see your dealer as soon as
possible to verify proper assembly.
Improper assembly may lead to loss of
braking capacity.