Table of Contents
Advertisement
Wait a few seconds and release the control knob.
2.
→ "Safety system", Page 9
Turn the control knob to the required position.
3.
If the burner does not ignite, turn the control knob to
4.
the off position and repeat the steps described
above. This time, hold the control knob down for
longer (up to 10 seconds).
Note:
Take the following information into account to ensure
that the appliance works correctly:
¡ The burner parts → Page 7 and the pan supports
→ Page 8 must be inserted correctly.
¡ Do not swap the burner caps around.
¡ It is important to keep the appliance clean. Clean
the ignition plugs regularly with a small, non-metallic
brush. Take care to prevent the ignition plugs from
suffering any heavy knocks.
¡ The burner holes and grooves must be clean to en-
sure a correct flame.
→ "Cleaning the burners", Page 10
7 Cookware
This information has been provided to help you save
energy and avoid damaging your cookware.
7.1 Suitable cookware
Only use cookware with a suitable diameter. The cook-
ware must not protrude over the edge of the cooktop.
Never use small cookware on large burners. The
flames must not touch the sides of the cookware.
Burner
Minimum dia-
meter of the
cookware base
Multi-crown
22 cm
burner
High-output
20 cm
burner
Standard-output
12 cm
burner
Only use cookware with a rounded base on the multi-
crown burner.
¡ The hob must have a multi-crown burner and addi-
tional wok grid.
8 Recommended settings for cooking
You can use the control knobs on the appliance to set
the flame height incrementally to different power levels
from 1 to 9.
The cooking times and power levels may vary depend-
ing on the type of food, its weight and quality, on the
type of gas used, and on the material from which the
cookware is made.
Maximum dia-
meter of the
cookware base
30 cm
26 cm
22 cm
6.2 Safety system
The safety system (thermocouple) interrupts the flow of
gas if the burners accidentally go out. To ignite the
burner, you must activate the system that enables the
gas flow.
Ignite the burner without releasing the control knob.
1.
a The flame ignites.
Press and hold the control knob for a further four
2.
seconds.
6.3 Switching off a burner
Turn the control knob clockwise to .
▶
6.4 Normal behaviour during operation
This behaviour is normal for the appliance:
¡ Slight hissing noise from the ignited burner.
¡ Release of odours when using the appliance for the
first time. These odours disappear after a short time.
¡ An orange flame is normal. This is due to dust in the
environment, spilled liquids, etc.
¡ Popping noise a few seconds after the burner is
switched off. This is caused by switching on the
safety system.
→ "Safety system", Page 9
¡ The additional wok grid must be correctly inserted.
→ "Accessories", Page 8
7.2 Using cookware
The selection and positioning of the cookware affects
the safety and energy efficiency of your appliance.
→ "Saving energy", Page 6
WARNING ‒ Risk of fire!
Flammable objects may ignite.
Maintain a distance of at least 50 mm between the
▶
cookware and flammable objects.
Do not use deformed
cookware. Only use cook-
ware with a thick, flat
base.
Place the cookware right
in the centre of the
burner.
Place the cookware cor-
rectly on the pan sup-
ports.
Cookware en
Deformed cookware is
not stable on the hob and
may tip over.
The cookware may tip
over if it is not placed in
the centre of the burner.
The cookware may tip
over if you place it directly
on the burner.
9
Advertisement
Table of Contents
