Table of Contents
Advertisement
Troubleshooting
If you experience problems with your TV, check below for advice. If you don't find a solution here, contact After Sales Support on 1300 886 649.
Problem
The remote control
does not work
The TV won't turn
on
There is no picture/
sound or distorted
picture/sound in
DTV mode
46 | TROUBLESHOOTING
Make sure that the batteries are installed with their poles (+/–) in the correct direction.
Remove any obstacles between the remote control and remote control sensor on the TV.
Check if the power indicator at the bottom of the TV blinks when you press the remote's power button.
If it does not, replace the remote control's batteries.
Try pointing the remote directly at the remote control sensor from 1.5-1.8m away.
Make sure that the AC power cord is securely plugged into the wall outlet.
Check the wall outlet is turned on and the power indicator at the bottom of the TV is lit.
If using a multi-outlet, check if it is working properly. To check whether a power strip is working properly, plug the
TV's power plug directly to a wall outlet and observe its operation.
Try to power on using the power button on the TV.
Ensure the antenna cable is securely connected to the TV and to the wall outlet.
Ensure the input source is set to DTV.
If "No Signal" is displayed, run Menu > Programmes > Programme Tuning > Auto Tuning
If some channels are missing, run Menu > Programmes > Programme Tuning > Manual Tuning
Try a different antenna cable or another TV if possible.
Move the TV away from electronic equipment or devices that could cause interference.
Adjust the antenna position.
If the picture appears fuzzy or blurry, select High Definition (HD) channels or programs.
Solution
Advertisement
Table of Contents
