KODAK PRINTOMATIC - Digital Instant Print Camera Manual

INTRODUCTION

Thank you for purchasing the KODAK PRINTOMATIC Digital Instant Print Camera. This User Guide is intended to provide you with guidelines to ensure that operation of this product is safe and does not pose risks to the user. Any use that does not conform to the guidelines described in this User Guide may void the limited warranty.

This product is intended for household use only. This product is covered by a limited warranty and is subject to conditions and exclusions. See warranty for details.

WARNINGS AND SAFETY PRECAUTIONS

• This camera is not waterproof or water-resistant. Exercise caution when using near water.
• Do not use the camera while you are walking, driving or riding a motorcycle as these actions may result in accidents.
• Do not point the flash close to anyone's eyes. This may cause harm to the person's eyesight.
• Turn the power off if:
  Foreign objects or water enter the camera.
  The camera has been dropped or damaged.
  Continued use after the foregoing issues may cause personal injury. Service should only be performed by a qualified technician.
• Use the camera in a well-ventilated area. Do not wrap the camera or place it in cloth or blankets. This may cause heat to build up and deform the housing, resulting in personal injury.
• Do not let sand or other particles get inside the camera, as damage may occur.
• Do not leave the camera in places where the temperature may rise significantly, such as inside a car or under direct sunlight. This may affect the performance of the product.
• This camera is a precision instrument. Do not drop, strike or use excessive force when handling the camera.
• Before moving the camera, disconnect all cords and cables. Failure to do so may damage cords and cables, resulting in personal injury or damage to the product.
• For optimal performance, use your KODAK PRINTOMATIC in temperatures between 60°F and 90°F (15.6°C and 32.2°C) and between 20% to 80% relative humidity.
• During extended use, your camera may feel warm to the touch. This is a normal operating occurrence and does not indicate any product defect or reason to slow down the fun.

BATTERY CARE AND CHARGING

Please carefully read and follow these guidelines.

• Your KODAK PRINTOMATIC camera is equipped with a built-in, non-removable 7.4V lithium-ion battery.
• To maximize battery performance and life, we recommend that upon first use you allow the battery to fully discharge before recharging it.
• To charge your camera, plug it into a wall outlet using a micro USB cable and any wall adapter rated for 1 Amp. The battery LED indicator will turn red until the battery is fully charged.
• Your KODAK PRINTOMATIC may take up to 2 hours to fully charge.
• Avoid extremely cold environments as low temperatures can shorten the battery life and reduce camera performance. Batteries should not be exposed to excessive heat, such as sunshine, fire or the like.
• Do not disassemble the camera or remove the battery at any time. The battery is not designed to be removed from the camera, or charged outside the camera. There is a danger of explosion if battery is incorrectly replaced, and should be replaced only with the same or equivalent type. Please contact our support team for service.
• When the battery power dips below 10%, the battery LED indicator will glow red and the camera will not print. At 2% power, your camera will automatically shut off.
• Please be sure to dispose of the camera device and battery at a properly designated recycling center in your local area.
  C&A Marketing UK Ltd is a registered producer of battery and accumulator products
  (Registration No. BPRN06318) and of electrical and electronic products
  (Registration No. WEE/ JK4235XX) in the U.K. For more information on proper disposal, please contact our support team.
  Lithium-ion batteries may cause environmental harm if disposed incorrectly.

PARTS AND FUNCTIONS

1. Strap Slot (strap not included)
2. Flash
3. Photo Print Exit Slot
4. Camera Lens
5. Micro USB Port
6. Reset Button
7. Speaker
8. MicroSD™ Card Slot
9. Viewfinder
10. Shutter Button
11. Power Button
12. Sliding Paper Compartment Door
13. Battery Indicator Light
14. Power/Printing Indicator Light

USING YOUR CAMERA

Turning On

• Press the power button, located on the top of the camera. Make sure your camera battery is fully charged.

Turning Off

• Press the power button to turn off the camera. The camera will automatically go into sleep mode after 5 minutes of inactivity.

Taking Photos

• Press the shutter button on the top right to take a photo. Your camera will automatically focus and activate the flash depending on the lighting conditions for each photo.

Printing

• The KODAK PRINTOMATIC camera uses only KODAK ZINK Photo Paper to instantly and automatically print 2" x 3" photos as soon as you snap them. Make sure the camera is loaded with KODAK ZINK Photo Paper.

Inserting Photo Paper

• Press down and slide the paper compartment door open.
• Slide the entire pack of KODAK ZINK Photo Paper into the paper tray.
• Each pack of KODAK ZINK Photo Paper includes a blue Color Calibration Sheet. Make sure the pack is loaded with the blue Color Calibration Sheet with the barcode facing down. The glossy side of the paper should be facing up.
• Close the paper compartment door.
• The blue Color Calibration Sheet will eject when you take your first picture, and then your photo will print.
  

Refilling Photo Paper

• Only load a single pack of 10 papers and the corresponding blue Color Calibration Sheet in the printer at one time when the printer is empty. The Color Calibration Sheet will be processed automatically at the start of each paper pack, calibrating the printer for that specific paper.

Paper Do's & Don'ts

• Do not add more paper until the paper compartment is completely empty.
• Do not fill the paper compartment with more than one 10-pack of KODAK ZINK Photo Paper. Filling over 10 sheets can damage the printer.
• Do not bend the KODAK ZINK Photo Paper.
• Do hold the paper by its edges. Avoid touching the surface with your fingers.
• When not in use, store KODAK ZINK Photo Paper at temperatures between 68°F and 77°F (20°C and 25°C).
• If you inserted the wrong type of paper, if there is a paper jam, or some other related error, the LED on top of the camera will blink red. Open your camera and correct the error (clear jam, replace paper, etc.) and then restart your camera.

Memory

• Your KODAK PRINTOMATIC is designed to capture and print immediately, and can hold up to 3 images at a time. To save your pictures use an external microSD™ card to extend its memory capacity.

Inserting a microSD™ Card

• Your KODAK PRINTOMATIC accommodates a 32GB microSD™ card. Gently slide the card into the slot at the bottom of your camera. You will feel a slight click when the card is fully inserted.

Removing a microSD™ Card

• Push on the top of the card to release it. Gently pull to fully remove the card from the camera.

MicroSD™ Card Error Indication

• When the memory on your microSD™ card reaches zero, or if there is an error reading the card, the LED on top of the camera will blink red.

Transferring Files to Your Computer

• Via USB Cable:
  Using a micro USB cable (not included), connect your KODAK PRINTOMATIC to a computer. Double-click the memory card image when it appears on your computer desktop to view and save your images.
• Via microSD™ Card:
  Remove the microSD™ card from the camera as indicated above. Insert the card into your card reader.

FAQ

Q Why are the colors on my prints coming out wrong?
A To ensure color accuracy, your camera's printer must be properly calibrated by the Blue Calibration Sheet inserted with the barcode facing down. This sheet has a unique barcode specific to each paper pack, so make sure not to mix paper from different packs together.

Q How do I charge my camera?
A To charge the battery in your camera, you will have to plug a micro USB cable (not included) into any wall adapter rated at 1 amp (not included). Using a computer or laptop to charge the camera is not recommended because it will significantly increase the charging time.

Q What do I do if the paper is stuck?
A Turn the printer off and on again and the printer will eject the paper. Do not try to pull out the paper by hand.

Q Why are my prints coming out blank?
A Please be sure that the KODAK ZINK Photo Paper pack is properly inserted in the camera. When loading the paper, the glossy side should be facing up. Please review the paper loading instructions included in this guide.

Q How many sheets can I put in at once?
A You can load one 10-pack of KODAK ZINK Photo Paper at one time.

Q Why are my pictures not centered?
A The frame marks on the view finder are set to a focus target 6 feet away. If you are taking pictures less than 6 feet from your target, the frame marks may not line up with the photo.

Q Why are my pictures coming out with lines?
A Make sure that your paper is properly inserted and that nothing is obstructing the exit slot where the pictures are dispensed. Also use the Blue Calibration Sheet with every paper pack to clean the print-heads. Do not aggressively shake your camera; it may interfere with the printing process.

Q What memory cards can be used with my camera?
A The KODAK PRINTOMATIC camera accepts microSD™ cards and flash memory cards from all brands.

Q Is a microSD™ card required for this camera?
A A microSD™ card is not required in order to use the camera. If you want to save your photos to your computer you will need to have a microSD™ or comparable memory card in your camera while you take your pictures.

Q Is any type of paper compatible with this camera?
A The KODAK PRINTOMATIC camera was designed to work only with KODAK ZINK Photo Paper. Other papers may be incompatible with this camera.

Q How do I turn on the flash for my camera?
A Your camera is equipped with a light sensor that will automatically turn on the flash in low light settings.

Q Can you choose when to print or does the camera print automatically?
A Your KODAK PRINTOMATIC camera prints automatically. Every picture taken will print after a few seconds.

Q Does the camera's printer print pictures from other devices?
A The KODAK PRINTOMATIC camera only prints the pictures you take from the camera. It does not connect to other devices.

CUSTOMER SERVICE

U.S.: kodak@camarketing.com, 844-516-1539
International: kodakintl@camarketing.com, +1-844-516-1540

The Kodak trademark, logo and trade dress are used under license from Eastman Kodak Company. PRINTOMATIC is a trademark of C&A IP Holdings, LLC in the U.S., the European Union and the United Kingdom.
ZINK, Zero Ink, and the ZINK logo are trademarks of ZINK Holdings, LLC, registered in the U.S. and other countries.
MicroSD is a trademark of SD-3C LLC in the U.S. and/or other countries.
Made for and distributed under license from Kodak by:
C&A Marketing, Inc., 114 Tived Lane East, Edison, NJ 08837 USA
C&A Marketing UK LTD, 167 Hermitage Road, Crusader Industrial Estate, London N4 1LZ, UK

©2020. C&A IP Holdings, LLC. All Rights Reserved.

To obtain Warranty Service and Troubleshooting contact information:
Visit our website at www.kodakphotoplus.com