Braun 8325s Manual page 19

This appliance is designed for household use
only.
Important
Keep power supply, charging stand, PowerCase
and cleaning station dry.
Do not open the appliance! The built-in rechargeable
batteries can only be replaced by an authorized
Braun Service center. Only at the end of the product's
useful life, disassemble the rechargeable battery for
disposal reasons: Disassemble the housing as shown
in the battery removal pictures, remove the recharge-
able battery and recycle or dispose of properly,
according to local guidelines.
Caution: Disassembling the appliance will
destroy it.
Recommended ambient temperature for charging is
41 °F to 95 °F / 5 °C to 35 °C, for storage and shaving
it is 60 °F to 95 °F / 15 °C to 35 °C. Do not expose the
appliance to temperatures higher than 122 °F / 50 °C
for extended periods of time.
The shaver head needs cleaning under hot running
water after each foam or gel usage! Switch the shaver
on and rinse until all residues have been removed.
For hygienic reasons, do not share this appliance with
other persons.
Shaver needs to be completely dry, when stored or
charged in the PowerCase. Wipe the PowerCase
with a damp cloth from time to time. For storage the
PowerCase should be fully charged and recharged
from time to time.
Product contains recyclable electric
waste. For environment protection, do
not dispose of in household waste, but
for recycling take to electric waste
collection points provided in your country.
Subject to change without notice
Description
1 Foil & cutter cassette 83M
2 Cassette release button
3 Multi head lock to lock the shaver head for a
precise shave
4 On/off button
5 Display
- Foil replacement indicator
- Travel lock indicator
- Cleaning station indicator
- Low charge / cordless use indicator
- Battery indicator with status bars and minutes
left (9 minutes and below)
6 Long hair trimmer
7 Contacts for cleaning station / PowerCase
usage
8 Release button to lift up long hair trimmer
9 Power socket
10 Cleaning station (see separate use instructions)
11 Charging stand
12 PowerCase
13 Power supply
Description PowerCase
12.1 Window to view the shaver display
12.2 Cleaning brush
12.3 Power socket
12.4 Battery status LEDs of the PowerCase
12.5 Start button to charge the shaver
(max. additional 50% battery power)
12.6 Contacts of the PowerCase need to align
with the contacts of the shaver
Note: Content may vary by model
Usage
A./B. Charging / Battery
C. a. Low charge
b. Cordless use
D. Shaving
E. Travel lock
F. Foil replacement
G. Automatic cleaning
H./I. Manual cleaning
J. Battery replacement
K. Charging of PowerCase
L. Charging of shaver in / from PowerCase
19