Table of Contents
Advertisement
Menu Option
Language
Projector Position
Menu Settings
High Altitude Mode
Security Settings
Panel Key Lock
Remote Control Code
Control Method
Baud Rate
Sets the language for the On-Screen Display (OSD) Menu.
Selects a proper position for the projector.
Menu Display Time
Sets the length of time the OSD Menu will remain active after
your last interaction.
Menu Position
Sets the OSD Menu's position.
We recommend you use the High Altitude Mode when your
environment is between 1,501 m to 3,000 m above sea level,
and ambient temperature is between 0°C–30°C.
NOTE:
• Do not use High Altitude Mode if your environment is
between 0 to 1,500 m, and the temperature is between
0°C to 35°C. If used, the projector will become over
cooled.
• Using "High Altitude Mode" may cause more operating
noise, as the fan speed will be increased to improve
cooling and performance.
See "Using the Password Function" on page 17.
Locks the control keys on the projector.
Sets the remote control code for this projector (between 1~8).
When multiple adjacent
time, switching the codes can prevent interference from other
remote controls. After the
the same ID for the remote control to control this projector.
To switch the code for the remote control, press
the number button corresponding to the remote control code
together for 5 seconds or more. The initial code is set to 1.
When the code is switched to 8, the remote control can control
every projector.
NOTE:
If different codes are set on the projector and remote
control, there will be no response from the remote
control. When that happens, a message will display to
remind you to switch the code for the remote control.
Allows you to select a preferred control port: through the
RS232 port or the USB port. When selecting USB, USB A Power
will be switched to Off automatically.
Selects a baud rate that is identical with your computer's so
that you can connect the projector using a suitable RS232 cable
and control the projector with RS232 commands
53
Description
projectors are in operation at the same
remote control code
is set, switch to
ID set
and
Advertisement
Table of Contents
