ViewSonic LS610WHE User Manual page 29

5. Please wait for around 15 - 20 seconds, and then re-enter the
page. The Projector IP Address,
settings will be displayed. Make note of the IP address displayed in the
Projector IP Address row.
NOTE:
• If the Projector IP Address still does not appear, contact your network
administrator.
• If the RJ45 cables are not properly connected, the Projector IP Address,
Subnet Mask, Default Gateway and DNS Server
sure the cables are properly connected and perform the procedures above again.
• If you need to connect to the projector in its standby mode, set
Standby LAN Control
• If you are in a non-DHCP environment:
1. Repeat steps 1-2 above.
2. Highlight LAN Settings
3. Contact your ITS administrator for information on the Projector IP Address,
Subnet Mask, Default Gateway, DNS Server
4. Press to select the item you want to modify and press Enter.
5. Press /
to move the cursor and the press
6. To save the settings, press Enter. If you do not want to save the settings, press
Exit.
7. Press to highlight Apply and press Enter.
NOTE:
• If the RJ45 cables are not properly connected, the Projector IP Address,
Subnet Mask, Default Gateway, DNS Server
sure the cables are properly connected and perform the procedures above again.
• If you wish to connect to the projector in its standby mode, be sure you
have selected
Default Gateway and DNS Server
Subnet Mask, Default Gateway, DNS Server
On
to in the
and press
Static IP and obtained the Projector IP Address,
settings will display 0.0.0.0. Make
ADVANCED LAN Control Settings
>
/ to select Static
settings.
/
to enter the value.
settings will display 0.0.0.0. Make
information when the projector is on.
29
LAN Settings
menu.
IP.
Subnet Mask,