Table of Contents
Advertisement
OPERATING INSTRUCTIONS
OPERATING YOUR PELLET STOVE
PRE-BURN INSTRUCTIONS:
operation. Check the hopper for enough pellets to start the unit.
Note: The thermostat mode can be changed during normal operation.
MANUAL MODE:
All control of circuit board function is adjusted at the circuit board.
9
To START: Press the ON / OFF button. The stove will turn on. The system light will flash. The
Auger Light will flash with each pulse of the auger (the Auger Feed Rate is pre-programmed during
start-up). The Heat Level Indicator will show the Heat Level that the stove will run at after start-up
and can be adjusted but the change will not take affect until the start -up has finished.
To PRIME AUGER: If this is the first time the unit has been started or the unit has run out of fuel,
the auger will need to be primed. This can be done by restarting the unit five (5) minutes into its
start-up or by putting a small hand full of pellets into the burnpot.
8
HEAT LEVEL
To OPERATE: When a fire has been established, the System Light will turn solid (after
approximately 10 - 15 minutes) and the Auger Light will continue to flash to the corresponding
Heat Level setting.
The convection blower (room air blower) will turn on. The speed of this blower is controlled by the
setting of the heat level output indicator. The convection blower can be turned off by depressing
7
the room air on/off button. For the best efficiency and to prevent cycling the convection blower
ROOM AIR
should be left on at all times.
FAN ON/OFF
HIGH/LOW MODE: (Requires a thermostat)
INITIAL START-UP: See manual mode above.
OPERATION: When the thermostat calls for heat (contacts are closed) the stove settings are
adjustable as per Manual Mode. When the thermostat contacts open, the HEAT LEVEL and Fans
will drop down to the LOW setting until the thermostat contacts close again. *The LOW heat
9
setting can be adjusted for different fuel qualities (see "O
F
"). The stove will come back to the previous HEAT LEVEL setting when the thermostat
unctiOns
contacts close again.
AUTO/OFF MODE: (Requires a thermostat)
INITIAL START-UP: See manual mode above.
OPERATION: When the thermostat contacts close, the unit will light automatically. Once up to
8
HEAT LEVEL
temperature, the stove operates the same as in MANUAL. When the thermostat contacts open, the
stove's HEAT LEVEL and Fans will drop down to the LOW setting for 30 minutes. If the thermostat
contacts close within the 30 minutes, the HEAT LEVEL will return to the previous MANUAL setting.
9
If the thermostat contacts remain open the stove automatically begins its shutdown routine. The
ON / OFF button can be pressed at any time and the stove will immediately shut down. The stove
will re-light when the thermostat contacts close again.
7
ROOM AIR
FAN ON/OFF
TURNING YOUR PELLET STOVE OFF:
8
HEAT LEVEL
• MANUAL and HI / LOW mode: To turn the unit OFF, simply press the ON / OFF button. This will
stop the feed of pellets. The blowers will continue to operate and cool the stove down. When
cool enough, the stove will turn off.
• AUTO / OFF mode: To turn the unit OFF, turn the thermostat down or off. NOTE: The unit will run
7
on low for three (3) minutes before it turns off.
ROOM AIR
DO NOT unplug unit while Combustion fan is operating.
FAN ON/OFF
This may lead to smoke escaping from the stove.
8
The burn pot liner holes must be clear and the liner installed properly against the ignitor tube for proper
DO NOT OPERATE THE UNIT WITH THE DOOR OR ASH PAN OPEN.
AUGER
MODE
AUTO/OFF
HIGH/LOW
MANUAL
FEED RATE
TRIM
COMBUSTION
BLOWER TRIM
ON/OFF
AUGER
MODE
C-11625
perating
AUTO/OFF
HIGH/LOW
MANUAL
FEED RATE
AUGER
TRIM
MODE
COMBUSTION
BLOWER TRIM
AUTO/OFF
HIGH/LOW
MANUAL
ON/OFF
FEED RATE
TRIM
C-11625
COMBUSTION
BLOWER TRIM
ON/OFF
C-11625
1
2
3
4
5
6
1
2
i
- c
B
nstructiOns
OntrOl
Oard
3
4
1
5
2
3
6
4
5
6
AUGER
MODE
AUTO/OFF
HIGH/LOW
MANUAL
Figure 1: Thermostat Switch in
MANUAL position.
COMBUSTION
BLOWER TRIM
ROOM AIR
ON/OFF
MODE
FAN ON/OFF
AUTO/OFF
HIGH/LOW
AUGER
MANUAL
Figure 2: Thermostat Switch in
HIGH/LOW position.
FEED RATE
AUGER
HEAT LEVEL
TRIM
MODE
COMBUSTION
BLOWER TRIM
AUTO/OFF
HIGH/LOW
MANUAL
ROOM AIR
ON/OFF
FAN ON/OFF
Figure 3: Thermostat Switch in
FEED RATE
ON/OFF position.
HEAT LEVEL
TRIM
COMBUSTION
BLOWER TRIM
ROOM AIR
ON/OFF
FAN ON/OFF
Starting a Fire in Your Pellet Stove
Greenfire Pellet Stove Owner's Manual
C-11625
C-11625
C-11625
Advertisement
Table of Contents
