Table of Contents
Advertisement
DISMANTLING / ASSEMBLING THE CASING
- Remove the front grill.
- Remove the filter, pulling it outwards horizontally
- Unscrew the fastening screws.
- Lift the casing in one piece, as shown in the figure.
VERTICAL INSTALLATION
For floor-standing assembly using the mouldings, see the
individual instruction sheets and the corresponding manual
for details on assembling the mouldings.
Use the paper template, and trace the position of the two
fastening brackets on the wall.
Drill the holes with a suitable drill bit and insert the anchors
(2 for each bracket); fasten the two brackets.
Do not fully tighten the screws, so as to be able to adjust the
brackets against a spirit level.
A anchors
B brackets
10
FDL3-i SLIM EN
Then secure the two brackets in place by completely tight-
ening the four screws.
Check stability by moving the brackets manually to the right
and left, up and down.
Fit the unit, making sure it is correctly attached to the brack-
ets and is stable.
A
B
A
B
I A
I A
Advertisement
Table of Contents
