FCC Class B Certification This equipment has been tested and found to comply with the regulations for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.
Thank you for choosing the 10/100BASE Fast Ethernet Media Converter, The Converter introduced here provides one channel media conversion between 10/100BASE-TX and 100BASE-FX. About Media Converter The Media Converter is a network technology specified by IEEE 802.3 10BASE-T, IEEE802.3u 100BASE-TX, and 100BASE-FX standards.
Product Features ?? One-channel media conversion between 10/100BASE-TX and 100BASE-FX ?? Fiber media allows: multi-mode fiber using SC, LC, or MT-RJ connector; sin gle-mode fiber using SC connector ?? Auto negotiation of speed and duplex mode on TX port ?? Auto MDI-X on TX port ?? One slide switch for configuring fixed half/full duplex modes ?? Store-and-forward mechanism...
Installation This chapter gives step-by-step installation instructions for the Converter. Selecting a Site for the Equipment As with any electric device, you should place the equipment where it will not be subjected to extreme temperatures, humidity, or electromagnetic interference. Specifically, the site you select should meet the following requirements: The ambient temperature should be between 32 and 104 degrees Fahrenheit (0 to 40 degrees...
Connecting to Power This Converter is a plug-and-play device. Connect the supplied AC to DC power adaptor with a power voltage of 7.5VDC/1.5Amp to the receptacle on the rear panel of the converter, and then attach the plug into a standard AC outlet with a voltage range from 100 to 260VAC.
Installing in a Chassis The Converter can be fit into any of the expansion slots on a special designed chassis (TFC-1600). Unscrew and pull out the media converter board ? First, install the converter onto a carrier supplied with the chassis: Step 1-...
LED Indicator The LED indicators give you instant feedback on status of the converter: LEDs State Solid (Power) Solid (100Mbps) Solid (FDX) Connection in full duplex mode FDX/COL TX Port (TX) FX Port (FX) Blinking (COL) Solid LINK/ACT (LINK) TX Port (TX) FX Port (FX) Blinking (ACT)
Operating Temperature Storage Temperature Humidity Emissions Ordering Information Please include the following information when ordering: Fiber type: multi-mode or single-mode Fiber connector type: SC, LC or MT-RJ Segment distance range for the fiber port Connector Type RJ-45 Connector Type Multi-Mode Fiber MT-RJ Multi-Mode Fiber Multi-Mode Fiber...