Electrical Safety - Stanley STPT600-B9 Manual

• Disconnect the appliance from the mains supply
- whenever you leave the machine;
- before cleaning a blockage;
- before checking, cleaning or working on the
appliance;
- if the appliance starts to vibrate abnormally.
• Store the appliance only in a dry place.
Labels on tool
The label on your tool may include the following symbols:
Hz ....... Hertz
Read
Instructions
W ........ Watts
Manual
min ..... minutes
Use Eye
Protection
..... Alternating
Use Ear
Protection
..... Direct
V ........ Volts
n ....... No-Load
0
A ........ Amperes
Position of date barcode
The Date Code, which also includes the year of
manufacture, is printed into the housing.
Example:
2014 XX JN
Year of manufacturing

Electrical safety

This tool is double insulated; therefore no earth
wire is required. Always check that the power
supply corresponds to the voltage on the rating
plate.
If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised Stanley Service centre in
order to avoid a hazard.
The extension cable must be suitable for outdoor use and
marked accordingly. Up to 0.75 mm² H05VV-F or H05RN-F
extension cable can be used without loss of product
performance.
Features
This tool includes the following features:
1. Nozzle
...... Class II
Construction
.... Earthing
Terminal
.... Safety Alert
Current
Symbol
.../min.. Revolutions
Current
or Recipro-
cation per
minute
Speed
(Original instructions)
2. Blast Port
3. Trigger Switch
4. Variable Speed Knob
5. Lock-On Button
6. Suction Port
7. Dust Bag
Assembly
Warning! Before assembly, make sure that the tool is
switched off and unplug.
Use
Mounting The Nozzle For Blowing Operations (fig. A)
• Insert the pin located inside the Nozzle into the notch
provided on the Blast Port (1)
• To lock Nozzle in place, turn the Nozzle in the direction
indicated.
• To remove Nozzle, turn the Nozzle in the opposite
direction.
Mounting The Nozzle And Dust For DustCollection
(fig. B)
• For dust collection, mount the Dust Bag at the Blast Port
(2) and Nozzle at the Suction Port (6)
• To remove Dust Bag and Nozzle, simply pull out by first
turning in the opposite direction.
• Empty the Dust Bag frequently to ensure maximum dust
collecting efficiency.
Operating The Blower (fig. C)
• To switch your Blower on, depress the Switch (3). To
stop your Blower, release Switch.
• Adjust Variable Speed Knob (4) for different speed
requirement.
• When continuous operation is required, first depress the
switch and then the lock-on button (5) and release to
disengage lock, squeeze and release switch.
Warning: Continuous running of machine should not exceed
30 minutes.
ENGLISH
5