Advertisement
LITTORA 200
U s e r m a n u a l
WALL-MOUNTING
OD SAT 5 (fig.7)
Before hanging the products, make sure the ceiling/walls are strong, in perfect condition, and are suitable to remain so long-
term. Use a professional to fix the wall brackets (E) and only use screws and dowels suitable for the materials. To mount the
loudspeakers, securely fasten the bracket using screws suitable for the materials. For a more discreet installation, thread the
cable through the hole in the middle of the mounting bracket and the notch on the base (fig. 16). Make sure to leave around
11
" (30cm) of cable to allow you to connect and position the loudspeaker easily afterwards. Next, direct the loudspeaker
3/4
towards the listening area and tighten the joints firmly with the locking screws (fig. 8).
GROUND MOUNTING
OD SAT 5 (fig. 9)
Mounting in the ground is only possible in soil or sand. They cannot be mounted in rigid metal, wood or concrete floors. Take
the stake (F) provided and plant it using your hand around 4-5cm into the ground. Then drive the stake in as far as it will go
using a suitable tool. For a more discreet installation, thread the cable through the hole in the middle and the opening on the
bottom of the stake. Make sure to leave around 11
easily afterwards. The stake can be cut down for installations in shallow ground. To help cut it, there are notches on the stake
at 4" and 7
" (10 and 20cm).
7/8
Attention: cutting the stake will create sharp edges which could cause injury.
Next, direct the loudspeaker towards the listening area and tighten the joints firmly with the locking screws (fig. 8).
OD SUB 12
To supply the listening area as best as possible, place the OD SUB 12 as close as possible to the centre of the system, avoiding
any pools (fountains, swimming pools, water sources, etc.). For more bass, move the OD SUB 12 nearer a wall (fig. 15). Prepare
the space for the sub by digging a hole measuring 13x34
Positioning (fig. 10 and 11): To get the most out of the sub, make sure there is a minimum 2
the part above the ground. Adjust the height of the vent to suit you by twisting it whilst positioned in its location.
Then cover the body with around 3/4" (2cm) of soil.
Warning: This product is only intended for use with the body underground.
CONNECTIONS
OD STONE 8
With its 5-strand cable, the OD STONE 8 adapts perfectly to 70/100V (fig. 5) or 8Ω (fig. 4) amplification. To do this, make the
appropriate connections using the waterproof cable connectors provided (B). To avoid any signal disturbance, ensure that any
strands that are not used are electrically insulated using suitable equipment.
8Ώ
Red
70/100V
Blue
OD SAT 5
The power of the OD SAT 5 is adjusted using the two-position notched selector on the back. To access it, remove the screw
on the back of the satellite (fig. 6).
Each position selects two values. It is the type of amplifier connected to the speaker that determines the power emitted by
the speaker.
" (30cm) of cable to allow you to connect and position the loudspeaker
3/4
+
-
Grey
Yellow
x15" (330x880x380mm) (fig. 10).
5/8
Short circuit
None
Red and Green
" (7cm) between the ground and
3/4
21
Advertisement
