Mains Power Connector; Wall Or Ceiling Mounting - Focal SHAPE User Manual

SHAPE
®
U s e r M a n u a l

8 - MAINS POWER CONNECTOR

Plug the supplied power cord into this connector.

9 - WALL OR CEILING MOUNTING

The attachment points enable you to mount your Shape studio monitors to the wall or to the ceiling.
The Shape 40 studio monitor is supplied with a plate so that it can be used with K&M® accessories.
The centre-to-centre distance is 2
10 - MOUNTING TO A TABLE STAND OR A MICROPHONE STAND
The fastening point underneath the Shape 40 and Shape 50 is for mounting the loudspeaker to a table stand or a
microphone stand.
The format required is BSW 3/8".
11 - LED ON THE FRONT PANEL
The LED on the front panel is off when the loudspeaker is set to OFF. When the ON/OFF switch is flipped from OFF
to ON, the LED lights up green. When an audio signal is detected, the loudspeaker switches from 'Standby' to 'On'
and the LED lights up green. After approximately 30 minutes without detecting an audio signal, the loudspeaker
automatically switches to 'Standby' to avoid unnecessary power consumption and the LED lights up red. In
'Standby' mode, power consumption is less than 0.5 W. To exit this mode, send an audio signal to the loudspeaker.
It takes a few seconds for the loudspeaker to switch from 'Standby' to 'On'.
See the diagram below for more information on fixing mechanisms.
See the table below for references of compatible K&M® products.
Shape 40
Shape 50
+ K&M® 24359 adapter
Shape 65
1
2
5
6
" (70 mm) for the Shape 40, 50 and 65. Use M6 screws.
3/4
Wall mount
Fixing kit K&M® 24471
Fixing kit K&M® 24471
Fixing kit K&M® 24471
+ K&M® 24357 adapter
PLATE : VERTICAL BRUSHED WITH BLACK ANODIZING
PRINTING : PANTONE P877C
APPROVED FOR PRODUCTION
Ceiling mount
Fixing kit K&M® 24496
Fixing kit K&M® 24496
+ K&M® 24359 adapter
Fixing kit K&M® 24496
+ K&M® 24357 adapter
3
4
7
9
8
Table stand / microphone
stand
Fixing kit K&M® 232
Fixing kit K&M® 232
-
10
2 inserts M6
11
18