Help - Motorola L702 Series User Manual

Doc Title : Product Data - User Manual
Model : Motorola L702 series

5. Help

The [Full Battery] icon is not scrolling when the cordless handset is placed on the charger
·Incomplete battery contact - adjust the cordless handset on the charger.
·Dirty contact - clean the battery contact by wiping with an alcohol moistened cloth.
·Battery is full - charging is not necessary at this time.
No dial tone
If there is no base power, check the connections. Reset the phone by unplugging then plugging it back into an
•
electrical outlet.
If the cordless handset batteries are empty, recharge the battery pack for at least 24 hours.
•
Move the cordless handset closer to the corded base.
•
Be sure to use only the provided telephone cords.
• • • •
Poor audio quality
If the corded base is too close to electrical appliances, reinforced concrete walls, or metal door frames, move the
•
corded base from these areas.
No ring tone
The ringer may be off.
•
The volume may need to be increased.
•
Caller ID does not work
Check your subscription with your network operator.
•
If you subscribe to high-speed internet service (Digital Subscriber Line - DSL) through your telephone lines, you
•
must install a DSL filter between the telephone base and the telephone wall jack. The filter will prevent noise and
caller ID problems caused by DSL interference. Please contact your DSL service provider for more information
about DSL filters.
A phonebook entry cannot be stored
The phonebook is full. Delete an entry to free memory
•
No display
Try recharging or replacing the rechargeable battery pack
•
Reset the corded base. Unplug the unit's electrical, then plug it back in.
•
If the LED is not lit up, then try to unplug the unit's electrical power, and then plug it back in.
•
If the cordless handset disconnects from the corded base during a phone call
Check that the power cord is connected properly into the corded base.
•
Check that the power adapter is connected properly into the electrical outlet.
•
Move the cordless handset closer to the corded base. It may be out of range.
•
Reset the corded base by unplugging the unit's electrical power.
•
Reset the cordless handset by unplugging and re-plugging its battery pack. Wait for around 15 seconds and re-
plug the power again. Allow up to one minute for the cordless handset to synchronize with the registered corded
base again.
Noise interference on your radio or television
Your corded base or cordless charger may be too close. Move it as far away as possible.
•
This document contains confidential and proprietary information of VTech Telecommunications Ltd
Revision :
Page(s) :
R.00
29 of 36