Replacing An Existing Router - TRENDnet TEW-432BRP Quick Installation Manual

3. Replacing an existing router

1. Select Yes, I am replacing
my existing router with a
new router and then click
Next.
2. Turn off or unplug power to
your cable or DSL modem.
Then click Next.
3. Unplug the power cable from
your old router and remove
its power supply from the
outlet.
4. Disconnect the Ethernet
cable from the port labeled
"WAN" or "Internet" on the
back of your old router. Plug
this cable into the grey port
labeled "WAN" on the
TEW-432BRP. Then click
Next.
5. Disconnect all remaining
Ethernet cables from the
back of your old router and
plug them into the yellow
ports on the TEW-432BRP.
Warning! DO NOT plug the cable or DSL modem power
supply into the TEW-432BRP.
6. Connect the included power
supply from an available
outlet to the TEW-432BRP.
7. Please wait while the router
is being configured.
8. Reconnect the power supply
to your cable or DSL modem.
Wait 30 seconds then click
Next.
5
English
8 0 0 2 5 . 0 3 . 0 n o s i e r V