Operation - Mitsubishi Electric Mr.SLIM SEZ-M71DA2 Operation Manual

2. Parts Names
I Outdoor unit

3. Operation

I About the operation method, refer to the operation manual that comes with each remote controller.
3.1. Turning ON/ OFF
3.1.1. For wired remote controller
[ ON]
Press the [ON/OFF] button.
The ON/OFF lamp will light up in
green, and the operation will start.
When "LED lighting" is set to "No," the ON/
OFF lamp will not light up.
* Refer to the installation manual of wired
remote controller.
Note:
Even if you press the ON/OFF button immediately after shutting down the operation is progress, the air conditioner will not start for about three minutes. This
is to prevent the internal components from b eing damaged.
I Operation status memory
Operation mode before the power was turned off
Operation mode
Preset temperature before the power was turned off
Preset temperature
Fan speed before the power was turned off
Fan speed
3.2. Mode select
3.2.1. For wired remote controller
Each pressing of the [F1] button cycles
through the following operation modes.
Select the desired operation mode.
• Operation modes that are not available to
the connected indoor unit models will not
appear on the display.
What the blinking mode icon means
The mode icon will blink when other indoor units in the same refrigerant
system (connected to the same outdoor unit) are already operated in a
different mode. In this case, the rest of the unit in the same group can
only be operated in the same mode.
6
Ref. Pipes
Indoor-Outdoor
Connection wire
Remote controller setting
C ool D r y F a n
A u t o He a t
Power
Earth
[ OFF]
Press the [ON/OFF] button again.
The ON/OFF lamp will come off, and
the operation will stop.
I Settab le preset temperature range
Operation mode Preset temperature range
Cool/Dry 19 – 30 °C
Heat 17 – 28 °C
Auto 19 – 28 °C
Fan/Ventilation Not settable
3.2.2. For wireless remote controller
I Press the operation mode (
operation mode 2.
►
Cooling mode
Drying mode
Fan mode
Heating mode
Automatic (cooling/heating) mode
Ventilation mode
Only indicated on the following condition
Wired remote controller used
LOSSNAY connected
) button ② and select the