Table of Contents
Advertisement
For all versions
0
1
3
Push the hand guard (1) forwards –
N
the saw chain is blocked
Simultaneously press the throttle
N
trigger lockout (2) and throttle
trigger – set the master control
lever (3):
Position choke shutter closed l
if engine is cold (even if the engine
–
has stalled during opening of
throttle after starting)
Position starting acceleration n
if engine is warm (once the engine
–
has been running for approx. one
minute)
Hold and start the chain saw
N
MS 171, MS 171 C, MS 181, MS 181 C, MS 211, MS 211 C
When the engine has turned over for the
first time
Move the master control lever to the
N
position starting acceleration n
Hold and start the chain saw
N
Once the engine is running
2
0
3
Press the throttle trigger lockout and
N
blip the throttle trigger (4); the
master control lever (3) jumps to the
operating position F and the engine
begins to idle
5
N
The chain brake is released – the chain
saw is ready for use.
4
Open the throttle only when the chain
brake is off. Increased engine speeds
with the chain brake on (saw chain is
stationary) will quickly damage the
clutch and chain brake.
At very low temperatures
N
Switch off the engine
N
Pull the hand guard toward the
handlebar
NOTICE
let the engine warm up briefly with
the throttle slightly open
Move the master control lever to the
stop position 0
English
33
Advertisement
Table of Contents
