Adding Nat Rules; The Napt Rule: Translating Between Private And Public Ip Addresses - TRENDnet TDM-C400 User Manual

Adding NAT Rules

This section explains how to create rules for each NAT flavor.
You cannot edit existing NAT rules. To change a rule setup,
delete it and add a new rule with the new settings.
Note
The rule: Translating between private and public IP
NAPT
addresses
Follow these instructions to create a rule for translating the private
IP addresses on your LAN to your public IP address. This type of
rule uses the NAT flavor
configuration. The
addresses to a single public IP address. The
translates the source port numbers to port numbers that are defined
on the NAT Global Configuration page (see page 119). The
introduction to NAT on page 117 describes how the
works.
1. Click the NAT tab, and then select NAT Rule Entry from the
NAT Options drop-down list.
The NAT Rule entry page displays, as shown on page 122.
2. Click
3. From the Rule Flavor drop-down list, select NAPT.
The page redisplays with only those fields that are appropriate
for the NAPT rule flavor:
Figure 51. NAT Rule – Add Page (NAPT Flavor)
Chapter 12. Configuring Network Address Translation
, which was used in your default
NAPT
flavor translates private source IP
NAPT
to display the NAT Rule – Add page.
rule also
NAPT
rule
NAPT
125