Table of Contents
Advertisement
TRENDnet User's Guide
•
Protocol – Select the protocol type to filter. TCP, UDP, or you can select * to
choose all protocol types.
•
Port – Enter the port number or port range numbers to block. (e.g. 80-80 or 20-
21).
•
IP Range – Enter the IP address or IP address range to apply the protocol/IP
filter. (e.g. 192.168.10.20-192.168.10.20 or 192.168.10.20-192.168.10.30).
Note: The filter will not be applied to IP addresses outside of the range
specified.
•
Add – Saves new protocol/IP filter.
To modify an existing protocol/IP filter, click on the entry in the Protocol/IP Filters list.
When selected, the entry will be highlighted.
•
Delete – Removes an existing protocol/IP filter.
•
Update – Modifies an existing protocol/IP filter.
•
Cancel – Discard changes to an existing protocol/IP filter.
© Copyright 2013 TRENDnet. All Rights Reserved.
Firewall rules
Access > Firewall Rule
You may want specify inbound or outbound access control to allow/deny sources (or
Internet IP addresses) to your network from the Internet or from computers or devices
on your network to the Internet. Firewall rules may allow for more granular control of
specific inbound and outbound access between your network and the Internet. It is
recommended that these settings remain set to default unless you are knowledgeable
about the effects of changing the firewall rule configuration. It is possible to have
undesirable functionality from your router if these settings are improperly modified.
1. Log into your router management page (see "Access your router management page"
on
page
27).
2. Click on Access, click on Filter, and click on Firewall Rule.
3. In the list, there are two default rules specific which cannot be modified. One rule to
deny all access from the Internet to your network for security and the other to allow all
access from your network to the Internet. Any additional rules will take precedence over
the default rules.
TEW-731BR
25
Advertisement
Table of Contents
