Advertisement
Step 7
7. Insert the plastic bushings (field supplied) into the holes in the bottom of the Contactor Mounting Plate Subassembly and run all power
and control wiring through the knockouts. See figure below.
Contactor mounting plate subassembly is only removable at the bottom. Contactor box mounting cover is designed to prevent water from
reaching the electrical components inside.
Figure 15: Contactor box cover and mounting plate subassembly
Contactor box cover.
Contactor mounting
plate assembly.
ALL wiring to the contactor MUST come out of the bottom
5/8" diameter holes. Use plastic bushings supplied with the
drain pan heater kit to protect wiring from sharp metal edges.
Verify the wires are routed such that they do not get pinched, placed in tension or rub against any sharp, metal edge prior to
securing.
Damaged wiring runs the risk of fire, electric shock, and physical injury or death.
Turn off power to outdoor unit before installation.
Electric shock can cause physical injury or death.
DRAIN PAN HEATER INSTALLATION
Due to our policy of continuous product innovation, some specifications may change without notification.
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. "LG" is a registered trademark of LG Corp.
21
Advertisement
