Pool Care And Chemicals; Long Term Storage - Intex Krystal Clear 603 Owner's Manual

• All pools require care to keep the water clear and hygienically clean. With
proper chemical control, your filter will help attain this objective. Consult your
pool supply dealer for instructions regarding the proper use of chlorine,
algaecide and other chemical agents required for sparkling clear water.
• Keep pool chemicals away from children.
• Do not replenish chemicals in pool while pool is occupied. Skin or eye irritations
could occur.
• Daily pH checking and chemical treatment of the water is very important and
can not be overemphasized. Chlorine, algaecide and maintenance of proper pH
levels are required when filling the pool as well as during the season. Consult
your local swimming pool supply store for instructions.
• The season's first filling of the pool may have brackish water requiring extra
water additives and extra filter changes. Do not allow swimming in pool until the
pH level is balanced. Consult your local swimming pool supply store for
instructions.
• Keep spare filter cartridges on hand. Replace cartridges every two weeks.
• Chlorinated water may damage lawns, gardens or shrubbery as children play
in the pool and splash water outside the pool. Lawn areas underneath the
pool liner will be destroyed. Note that some types of grass may grow through
the liner.
• Filter run time depends on pool size, weather and usage level. Experiment with
various run times so as to produce clean clear water.
Concentrated chlorine solutions may damage the pool liner. Always
follow the chemical manufacturer's directions, and the health and
hazard warnings.
1. Before emptying your pool for long term storage, or relocation, be sure the
water is directed towards an acceptable drain water receptacle away from
the house. Check local regulations for specific directions regarding disposal
of swimming pool water.
2. Now, drain the pool.
3. When the pool is empty, disconnect all pool hoses (8) from the pool and filter
pump, simply reverse the set up instructions.
4. Remove the filter cartridge as shown in the Filter Cartridge Cleaning section,
steps 2 thru 4.
5. Remove the nozzle and strainer unions from the pool wall. Place the wall
plugs into the hose connections. Loosen clamps (7) securing the strainer
connectors (9) before removal.
6. Drain water from the filter pump housing.
7. Leave filter pump pieces and hoses outside to thoroughly air dry.
8. Depending on the cartridge (5) usage, a new cartridge may be needed for
next season, keep a spare available.
9. Cover the seal (4), air release valve O-ring (2) and hose seals (6) with
petroleum jelly to preserve its resilience during storage.
10. Store the unit and accessories in a dry place. The storage's temperature
should be controlled, between 32 degrees Fahrenheit (0 degrees Celsius)
and 104 degrees Fahrenheit (40 degrees Celsius) storage location.
11. The original packing can be used for storage.
SAVE THESE INSTRUCTIONS
(57) MODEL 603 FILTER PUMP ENGLISH 7.5" X 10.3" PANTONE 295U 11/08/2011

POOL CARE AND CHEMICALS

CAUTION

LONG TERM STORAGE

English
57
Page 8