Ip Address Filtering - TP-Link TL-WR543G User Manual

Enable Firewall - the general firewall switch is on or off.
Enable IP Address Filtering - set IP Address Filtering is enabled or disabled. There are two
default filtering rules of IP Address Filtering, either Allow or Deny passing through the router.
Enable Domain Filtering - set Domain Filtering is enabled or disabled.
Enable MAC Filtering - set MAC Address Filtering is enabled or disabled. You can select the
default filtering rules of MAC Address Filtering, either Allow or Deny accessing the router.

4.9.2 IP Address Filtering

The IP address Filtering feature allows you to control the Internet Access by specific users on
your LAN based on their IP addresses. The IP address filtering is set on this page, Figure 4-38:
To disable the IP Address Filtering feature, keep the default setting, Disabled. To set up an IP
TL-WR543G 54M Wireless AP Client Router User Guide
Figure 4-37 Firewall Settings
Figure 4-38 IP address Filtering
- 46 -