Wan - TP-Link TL-WR543G User Manual

Subnet Mask - An address code that determines the size of the network. Normally use
255.255.255.0 as the subnet mask.
Note:
a. If you change the IP Address of LAN, you must use the new IP Address to login the router.
b. If the new LAN IP Address you set is not in the same subnet, the IP Address pool of the
DHCP server will not take effect, until they are re-configured.
c. If the new LAN IP Address you set is not in the same subnet, the Virtual Server and DMZ
Host will change accordingly at the same time.

4.5.2 WAN

You can configure the WAN port parameters on this page.
First, please choose the WAN Connection Type (Dynamic IP/Static IP/PPPoE/802.1X + Dynamic
IP/802.1X + Static IP/Big Pond Cable/L2TP/PPTP) for the Internet. If the device works in the AP
Client mode, it only provides five kinds of connection type, "Dynamic IP", "Static IP", "PPPoE",
. The default type is Dynamic IP. If you aren't given any login parameters (fixed
"L2TP", and "PPTP"
IP Address, logging ID, etc), please select Dynsamic IP. If you are given a fixed IP (static IP),
please select Static IP. If you are given a user name and a password, please select the type of
your ISP provided (PPPoE/BigPond/L2TP/PPTP)
use currently, please contact your ISP to obtain the correct information.
1. If you choose Dynamic IP, the router will automatically get IP parameters from your ISP.
You can see the page as follows (
This page displays the WAN IP parameters assigned dynamically by your ISP, including IP
address, Subnet Mask, Default Gateway, etc. Clicks the Renew button to renew the IP
parameters from your ISP. Click the Release button to release the IP parameters.
MTU Size - The normal MTU (Maximum Transmission Unit) value for most Ethernet networks
TL-WR543G 54M Wireless AP Client Router User Guide
Figure 4-5
Figure 4-5 WAN – Dynamic IP
- 16 -
If you are not sure which connection type you
.
):