Chapter 3. Adjustment - Furuno 1932 MK2 Service Manual

WARNING
Hazardous Voltage
This equipment uses high voltage electricity which can SHOCK, BURN or cause DEATH.
Always make sure the electrical power is turned off before attempting to change a component or
inspecting the inside of the equipment. A residual charge may exist in capacitors, even with the
equipment turned off. Always short all supply lines to the chassis with an insulated screwdriver or
a similar tool before touching the circuit.
Working on the Scanner Unit Mast
Work on the scanner unit mast is dangerous, and doubly so if the proper precautions are not taken.
1) Post an appropriate warning sign near the display unit to indicate that work on the scanner unit
is being performed, to prevent accidental application of the power to the scanner unit.
2) Wear a safety helmet and always be aware of where the scanner radiator is.

Chapter 3. Adjustment

IMPORTANT!
SAFETY INFORMATION
Be sure to read all the safety information which
follows before perfoming any adjustment.
3-1