Section Three Cleaning (Users Instructions) - Infinity 600 FL Owner's Manual

SECTION THREE Cleaning (users instructions)

Warning: -
Before you clean any part of the appliance ensure that the appliance is turned off and cold.
CLEANING: PILOT ASSEMBLY
(Before cleaning ensure that the appliance is turned off and cold)
In some instances you may experience ignition problems even when the appliance is new. This may be due to the
aeration hole in the pilot body being partial blocked with dust, pet hairs, or other foreign matter. The source of this
debris could be such things as carpet fibres, decorating or pet etc.
To gain access to the pilot please do the following.

Remove the two side covers LH and RH.

Undo the two M4 nuts retaining the glass fixing bracket using the tool provided then pull clear and from the
location studs.

Carefully lift the glass panel from within the bottom location slot.

Remove the log fuel bed shapes and bark shapes.

Lift out the air tray assembly from the location points within the shelf.
The pilot is located on the right hand side of the appliance, any debris in or around the aeration hole should be remove
using the nozzle of a vacuum cleaner. It is advisable not to blow the debris into the hole as this may cause more of a
restriction and not rectify the problem.
Note: - Take care when cleaning in this area so as not to damage the pilot assembly.
REMOVING GLASS PANEL

Remove the two side covers LH and RH which are held on with magnets.

Undo the two M4 nuts retaining the glass fixing bracket using the tool provided then pull clear from
location studs.
Carefully lift the glass panel from within the bottom location slot.
10 LT6125 (ISS 13)