Table of Contents
Advertisement
Appendix C: Software Installation Instructions
Appendix C
Software Installation Instructions
After all the hardware has been installed, you must first configure the
Adaptec Embedded Serial ATA RAID Driver before you install the Windows
operating system. The necessary drivers are all included on the Supermicro
bootable CDs that came packaged with your motherboard.
(*For
Adaptec's SCSI HostRAID Utility, please refer to the CDs that came
with your motherboard.)
C-1 Introduction to the Adaptec Embedded Serial ATA RAID
Controller Driver
Serial ATA (SATA)
Serial ATA(SATA) is a physical storage interface. It uses a single cable with a
minimum of four wires to create a point-to-point connection between devices.
It is a serial link which supports SATA Transfer rates from 150MBps. Because
the serial cables used in SATA are thinner than the traditional cables used in
Parallel ATA(PATA), SATA systems have better airflow and can be installed in
smaller chassis than Parallel ATA. In addition, the cables used in PATA can
only extend to 40cm long, while Serial ATA cables can extend up to one meter.
Overall, Serial ATA provides better functionality than Parallel ATA.
Introduction to the Intel ICH5R I/O Controller Hub
Located in the South Bridge of the Intel E7520 (Lindenhurst) Chipset, the ICH5R
I/O Controller Hub provides the I/O subsystem with access to the rest of the
system. It supports 2-channel Ultra ATA/100 Bus Master IDE controller (PATA)
and two Serial ATA (SATA) Host Controllers, which support up to two Serial
ATA ports and up to two RAID drives.
C-1
Advertisement
Table of Contents
