McCulloch Rider 11 Workshop Manual page 47

2
Adjusting Rider 11 Bio and Rider 13 Bio
• Remove the front cover and the right-hand
fender.
• Unscrew the nut (1) from the parallel strut.
Remove the clip (3) and the parallel strut (2).
• Turn the fork anti-clockwise to lower the rear
edge of the hood, or clockwise to raise the rear
edge of the hood.
• Once adjustment is complete, refit the parallel
strut and clip and tighten the nut.
• Recheck the alignment of the cutting unit after
adjustment.
• Refit the right-hand fender and hood.
2
Adjusting Rider 16
• Remove the front cover and the right-hand
fender.
• Undo the nuts on the lift strut.
• Unscrew the strut (anticlockwise) to lower the
rear edge of the hood.
Screw the strut in (clockwise) to raise the rear
edge of the hood.
• Tighten the nuts after adjustment.
• On completion of the adjustment the unit's
parallelism should be re-checked.
• Fit the right-hand fender and the front hood.
Reparation instructions
45
English –