Table of Contents
Advertisement
Delivery and dealer service
The following is a list of the maintenance which should be conducted on the machine. Most of the points that
are not covered by this workshop manual are covered by the operator's manual.
Maintenance
Check the oil level in the engine
Check the engine's cooling air intake
Check the fuel pump's air filter
Check the steering wires
Check the brakes
Check the battery
Check the safety system
Check the screws and nuts
Check if there is any fuel or oil leakage
Change the engine oil
Clean the air filter's pre-filter (foam plastic)
Check the mower deck
Check the tyre pressures (60 kPa)
Lubricate the belt tensioner
Lubricate joints and axles
Adjust the brakes, Rider 11
Check the V-belts
Check the transmission's cooling fins,
Rider 13 and Rider 16
Check the transmission's oil level,
Rider 13 and Rider 16
Adjust the brakes, Rider 13 and Rider 16
Check and adjust the throttle wire
Clean the cooling fins on the engine and transmission
Replace the air filter's pre-filter and paper filter
Replace the fuel filter
Replace the spark plug
1)
First change after 5 hours.
2)
be lubricated twice a week if used daily.
= Described in this Workshop Manual.
= Not described in this Workshop Manual.
= Described in the Operating Instructions.
WARNING!
No service procedures must be conducted on the engine or cutting unit unless:
•
The engine is switched off.
•
The ignition key is removed.
•
The ignition cables are removed
from the plugs.
8
– English
Maintenance schedule
1)
2)
3)
3)
Cleaning and replacing should be carried out more frequently in dusty conditions.
4)
Carried out by authorised service workshop.
Daily
maintenance
Page
before
starting
11
-
-
25
28
10
57
-
-
25
-
44
12
-
-
28
-
-
43
28
23
2,4)
-
2)
-
-
-
•
The parking brake is applied.
•
The cutting unit is disengaged.
Maintenance interval in
hours
25
50
100
3)
The machine should
Advertisement
Table of Contents
