Connecting The Power Cord; Inserting Batteries In The Remote Control - Grundig Sonoclock 890 A WEB Manual

CONNECTION­AND­PREPARATION
Connecting­the­power­cord
Note:­
Check that the mains voltage on the
7
type plate (on the back of the device)
corresponds to your local mains supply. If
this is not the case, contact your specialist
dealer.
1 Plug the power cord into the wall socket.
Caution:
The device is connected to the mains with
7
the power cord. Pull out the power plug
when you want to completely disconnect
the device from the mains.
Unplug the mains plug to disconnect the
7
device from the mains. Make sure the power
plug is easily accessible during operation
and not hindered by other objects.
12­
ENGLISH
Inserting­batteries­in­the­remote­
control
1 P ull off the film from the battery.
2 Take off the battery compartment cover (screw
cap).
3­
When inserting the battery (3 V, lithium, CR
2025), make sure the positive terminal (+) is
facing upwards and the buttons on the remote
control are facing downwards.
•
OPEN •
•
4 Replace the battery compartment cover
(screw cap) and fasten it.
Notes:­
Do not expose the battery to extreme heat,
7
caused for example by direct sunlight,
heaters or fire.
If the device no longer reacts properly to
7
remote control commands, the battery may
be flat. Always remove used batteries.
The manufacturer accepts no liability for
damage caused by leaking batteries.
Environmental­note:
Batteries, including those which contain
7
no heavy metal, should not be disposed
of with household waste. Always dispose
of used batteries in accordance with local
environmental regulations.
­---------------------------------------
LOCK