Control Panel; Operating Modes - Danby DPA100B9IWDB-RF Owner's Manual

OPERATING INSTRUCTIONS

CONTROL PANEL

1. Swing and wireless connect button:
• Press to start the auto swing feature.
• Press and hold for three seconds to start
using the wireless connect feature.
2. Timer button: Press to set the automatic timer.
Light will indicate whether a timer is set.
3. Mode button: Press to select the desired mode.
Light will indicate current mode.
4. Temperature control buttons:
• Press to modify the set temperature in 1°
increments in a range of 16 - 30°C (60 -
86°F).
• Press to modify the timer setting in 0.5 hour
increments up to 10 hours and then in 1
hour increments up to 24 hours.
• Press and hold both temperature control
buttons for three seconds to change the
temperature display from °C to °F.
5. LED display:
• Shows the set temperature in °C or °F.
• Shows the timer settings.
• Shows error codes.
• When on fan mode, shows the room
temperature.
6. Fan button:
• Press to select fan speed. Light will indicate
current speed.
• Press and hold for 3 seconds to turn the
continuous fan on or off.
7. Sleep and fi lter button:
• Press to start the sleep feature.
• The fi lter light will illuminate after 250 hours
of use as a reminder to clean the fi lter; to
reset the fi lter after cleaning, press and hold
the sleep button for three seconds.
8. Power button: Press to turn the appliance on or
off.
4
1 2 3
3sec
5
6
7
3sec

OPERATING MODES

Cool Mode
• Choose cool mode to set the cooling function.
• Use the temperature control buttons to choose the
desired temperature.
• Use the fan button to choose the desired fan
speed.
• The temperature can be set within a range of 16 -
30°C (60 - 86°F).
• The exhaust hose should be installed.
Dry Mode
• Choose dry mode to remove excess moisture from
the air. Water will condense inside the appliance
and drain out the back.
• The humidity level and fan speed will be
automatically set and cannot be modifi ed in dry
mode.
• The exhaust hose does not need to be connected
to the window kit.
• It may be necessary to install the continuous drain
hose during dry mode to remove excess water.
Fan Mode
• Fan mode can be used to run the fan without
engaging the cooling or dehumidifying functions.
• Use the fan button to choose the desired fan
speed.
• The exhaust hose does not need to be connected
to the window kit.
• In cooling or dry mode, press and hold the
fan button for 3 seconds to set the fan to run
continuously. Press and hold the fan button for 3
seconds to disengage the continuous fan. During
normal operation the fan will turn on and off with
the compressor.
Auto Mode
Auto mode is a pre-set factory program that
automatically defi nes the mode and fan speed based
on the set temperature and the ambient temperature.
The exhaust hose should be installed during auto
mode.
8
13