Table of Contents
Advertisement
Figure 6-3.
6-4
Drive Bay Installation
A bezel covers the front of the chassis but does not need to be removed to
access the drives.
three tabs on the inside left side lip of the front chassis cover.
slightly swing out the same (left) side of the cover - about ½ inch only.
Remove by pushing on the open side of the cover to remove it from the
chassis (do not try to swing or pull it straight out after opening the left side.
SCSI Drives
After unlocking the SCSI drive bay door swing it open to access the SCSI
drives.
SCSI drive IDs are preconfigured as 0 through 6 in order from
bottom to top (or from left to right if rackmounted) - see Figure 6-1.
Note: You must use standard 1" high, 80-pin SCA SCSI drives.
Use extreme caution when working around the SCSI
backplane.
!
metal objects and make sure no ribbon cables touch
the backplane or obstruct the airflow holes in the
SCSI backplane.
Removing the 12-cm Exhaust Fan
If you wish to remove the bezel piece, push on the
Do not touch the backplane with any
6-5
Chapter 6: Advanced Chassis Setup
Then
Advertisement
Table of Contents
