Drilling holes Drill the holes on top of wooden cupboard ● drill Ø 7mm hole ● cut Ø 165mm hole Ø7 for hood fastening screws 165 for flue Ø clearance Door/hood fascia Fixing the ducting adapter Connect Ø120mm ducting adapter to the blower outlet and use screws to fix it to the range hood.
Page 9
Fixing the Lateral spacers ST3 x 12mm Mounting the rangehood to the underside of cupboard...
Page 10
Fixing the Rear Spacer Screw ST3 x 12mm Rear spacer can be reversed to suit gap at rear Fixing flexible duct Connect Ø125 mm flexible duct to the adapter and fix it.
OPERATING INSTRUCTIONS Control panel features Right Warning: the lighting should not be used as permanent light source but only for cooking. CLEANING AND MAINTENANCE Warning: always switch off the electricity supply before carrying out maintenance work on the hood. In the event of a fault, contact an official distributor or Customer Service.
Page 12
Replacing the lamp Note that lamps become hot when in use. Allow the lamps to cool down for a few minutes before changing them. FUSE 1 MONTH ≤ 65ºC...
≤ 65ºC Replacing Activated charcoal filters Replace Activated charcoal every 3 months 3 MONTHS Troubleshooting Problem Possible cause Solution Excessive vibration. The appliance is not installed Take down the appliance and check properly on the brackets. The fan blade is damaged. Switch off the appliance.
Recycling & disposal The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment.