Table of Contents
Advertisement
SENSOR ALIGNMENT
Perform this adjustment after the "holder (disc A2) adjustment".
If the disc table swings to the left and right just before the disc is
chucked, perform the following adjustment.
cam
(1) Rotate the cam and adjust to the position
shown in the figure.
(2) Check that the lever (stopper) ass'y secures
the disc table as shown in the figure.
lever (stopper) ass'y
tapering screwdriver
LUMINOUS board
bracket (sensor)
(3) Loosen the fixed screw by 60° to 90°, and use a tapering screwdriver to adjust the screw as shown in the figure.
Move the bracket (sensor) with the tapering screwdriver little by little, and fix the fixed screw at where the play button's LED (green)
is switched to the pause button's LED (orange) (or its reverse).
bracket (sensor)
disc table
fixed screw
– 16 –
cam
table ass'y
(4) Moving the disc table right and left with a hand after the
screw is fixed, the table will move by the play of a disc table.
If the LEDs light up alternately, the adjustment will be per-
formed correctly.
PLAY button
lever (stopper) ass'y
swing
PAUSE button
Advertisement
Table of Contents
