Before Using For The First Time; Basic Operation - Siemens LC65KDK20 User Manual And Installation Instructions

en Before using for the first time

Before using for the first time

6 Before using for the first time
Configure the settings for initial start-up. Clean the ap-
pliance and accessories.
6.1 Setting an operating mode
Your appliance is set to air extraction mode by default.
Note: When using it in circulating-air mode, you require
additional accessories.
Setting the saturation indicator
The saturation indicator must be adjusted depending
on the filter used.

Basic operation

7 Basic operation
7.1 Switching on the appliance
Press ⁠ .
▶
a The appliance is activated for one minute.
7.2 Setting a fan setting
Press ⁠ , ⁠ or ⁠ to adjust the fan setting.
▶
7.3 Switching off the appliance
Press twice.
▶
7.4 Switching on intensive mode
If particularly strong odours or vapours develop, you
can use intensive mode.
Press ⁠ .
▶
a The appliance automatically switches off after ap-
prox. 6 minutes in the previous state.
7.5 Switching off intensive mode
Press or set another fan setting.
▶
a Intensive mode is ended early.
Cleaning and servicing
8 Cleaning and servicing
To keep your appliance working efficiently for a long
time, it is important to clean and maintain it carefully.
8.1 Cleaning products
You can obtain suitable cleaning products from after-
sales service or the online shop.
ATTENTION!
Unsuitable cleaning products may damage the sur-
faces of the appliance.
Do not use harsh or abrasive detergents.
▶
Do not use cleaning products with a high alcohol
▶
content.
Do not use hard scouring pads or cleaning
▶
sponges.
20
Note: The saturation indicator for the grease filter is set
as standard. For use in the circulating-air mode, you
must also activate the saturation indicator for the odour
filter.
Requirement: The appliance is switched off.
Press and hold and
▶
lights up briefly first and then and
a
up at the same time.
a The saturation indicator for the odour filters is activ-
ated.
7.6 Switching on the lighting
The lighting can be switched on and off independently
of the ventilation system.
Press ⁠ .
▶
7.7 Switching off the lighting
Press ⁠ .
▶
7.8 Saturation indicator
The saturation indicator informs you about when the
grease filter has to be cleaned and when you have to
change the odour filter.
¡ If the grease filter has to be cleaned, flashes.
¡ If the odour filter needs to be replaced,
After cleaning the grease filter and/or changing the
odour filter, the saturation indicator should be reset.
Resetting the saturation indicator
Requirement: The appliance is switched on.
Press and hold for 3 seconds.
▶
a The saturation indicator is reset.
a or stops flashing.
Only use glass cleaners, glass scrapers or stainless
▶
steel care products if recommended in the cleaning
instructions for the relevant part.
Wash sponge cloths thoroughly before use.
▶
8.2 Cleaning the appliance
Clean the appliance as specified. This will ensure that
the different parts and surfaces of the appliance are
not damaged by incorrect cleaning or unsuitable clean-
ing products.
for 3 seconds.
briefly light
flashes.