Table of Contents
Advertisement
Before using for the first time
Displaying and setting the water
hardness
Switch the dishwasher off with the
button, if it is switched on.
Press the Start button in and, whilst
holding it in, switch the dishwasher
on using the button.
Keep the Start button pressed in for
at least 4 seconds until the Start in-
dicator light comes on.
If this does not happen, start the pro-
cedure from the beginning again.
Press the programme selector 2
times.
The left programme indicator light will
flash rapidly 2 times at intervals.
24
The value set for the water hardness is
shown as a figure after in the time dis-
play.
will start flashing in the time display.
A water hardness of 14 °dH is set.
Use the Start button to set the water
hardness value in your area.
The dosage amount increases each
time you press the button. When the
highest value is reached, the setting
starts again from the beginning.
The setting is now saved.
Switch the dishwasher off with
the button.
Advertisement
Table of Contents
