Husqvarna K 540i Operator's Manual page 19

• Divide the pipe into 5 sections. Do a mark of those
sections and of a cutting line. Cut a shallow guide
groove around the pipe.
4
1
• Cut those sections in 5 steps with the cutting
directions shown by the arrows in each step.
•
2
•
3
1960 - 002 - 25.08.2023
5
3
2
1
•
• Make the final separating cut from the top of the
pipe pulling backwards, without involving the upper
quadrant of the blade. Adjust the blade guard to full
forward position for maximum protection.
WARNING:
supported, it should not pinch the blade
when separated in section 5. However
be alert if the blade is pinched during the
final separation. If the blade is pinched
in the lower section, the product may pull
forward away from the operator, rather
then resulting in a rotating kickback.
To prevent a kickback
WARNING:
there is a risk of kickback. Take care when
using your power cutter and make sure that
the blade is never pinched in the kickback
zone.
WARNING:
the blade in an existing cut.
WARNING:
work piece cannot move during a cutting
operation.
WARNING:
working technique can eliminate kickback
and its dangers.
4
5
If the pipe is properly
Avoid situations where
Be careful when you put
Make sure that the
Only you and proper
19