Installing The Catalytic Converter - Tightening Specification And Sequence - Volkswagen Jetta Hybrid 2014 Quick Reference

8 - Bolt
Not installed
…
9 - Bolt
Not installed
…
10 - Front Exhaust Pipe with Catalytic Converter
11 - Screw-Type Clamp
Tightening specification and sequence, see Installing the Catalytic
…
Converter - Tightening Specification and Sequence below
12 - Seal
Replace after removing
…
13 - Turbocharger
14 - Nut
30 Nm
…
15 - Front Clamping Sleeve
Installing the Catalytic Converter -
Tightening Specification and Sequence
Stage
1 Place the catalytic converter -1- on
the turbocharger and loosely attach
a new v-clamp -6-.
2 - Loosely install nuts -2, 4 and 5- by
hand.
● Catalytic converter -1- and bracket
-3- need to be able to move.
3 Tighten v-clamp -6-.
4 Tighten all bolts and nuts.
VW Jetta Hybrid Quick Reference Specification Book • February 2014
Bolts and Nuts Tightening specification
Tighten loosely hand tight.
Tighten loosely hand tight.
15 Nm
20 Nm
91