Table of Contents
Advertisement
What to do if...
Problem
There is no spark when you try to
activate the spark generator.
There is no spark when you try to
activate the spark generator.
There is no spark when you try to
activate the spark generator.
The flame ring is uneven.
The burners do not work.
The appliance makes noises.
The flame colour is orange or yel-
low.
The lamp does not operate.
Steam and condensation settle
on the food and in the cavity of
the oven.
The oven does not heat up.
The turnspit does not rotate.
It takes too long to cook the
dishes or they cook too quickly.
Service data
If you cannot find a solution to the problem
yourself, contact your dealer or an Authorised
Service Centre.
www.zanussi.com
Possible cause
The hob is not connected to an
electrical supply or it is connec-
ted incorrectly.
The fuse is released.
Burner cap and crown are placed
incorrectly.
Burner crown is blocked with
food residues.
There is no gas supply.
The lamp is defective.
You left the dish in the oven for
too long.
The necessary settings are not
set.
The turnspit is not correctly in-
stalled into the turnspit hole.
The temperature is too low or too
high.
The necessary data for the service centre is on
the rating plate. The rating plate is on the front
frame of the appliance cavity. Do not remove
the rating plate from the appliance cavity.
Remedy
Check if the hob is correctly con-
nected to the electrical supply.
Refer to the connection diagram.
Make sure that the fuse is the
cause of the malfunction. If the
fuse releases again and again,
contact a qualified electrician.
Place the burner cap and crown
correctly.
Make sure that the injector is not
blocked and the burner crown is
clean.
Check the gas connection.
Some metal parts of the appli-
ance expand and contract when
they heat up or cool down. The
noises are normal.
The flame can look orange or yel-
low in some areas of the burner.
This is normal.
Replace the lamp.
Do not leave the dishes in the
oven for longer than 15 - 20 mi-
nutes after the cooking process
ends.
Make sure that the settings are
correct.
Refer to "Using the turnspit".
Adjust the temperature if neces-
sary. Follow the advice in the
user manual.
19
Advertisement
Table of Contents
