Page 1
Dryer User Manual DHR 73431 B 2960311301_EN/231116.1514...
Page 2
Please read this user manual first! Dear Customer, Thank you for prefering a Beko product. We hope that your product which has been manufactured with high quality and technology will give you the best results. We advise you to read through this manual and the other accompanying documentation carefully before using your product and keep it for future reference.
Important instructions for safety and environment This section contains safety instructions that will help protect from risk of personal injury or property damage. Failure to follow these instructions shall void any warranty. 1.1 General safety • The dryer can be used by children at and above 8 years old and by persons whose physical, sensory or mental capabilities were not fully developed or who lack experience and knowledge provided that they are...
Important instructions for safety and environment 1.1.1 Electrical safety Electrical safety instructions should be followed while electrical connection is made during the installation. The appliance must not be supplied through an external switching device, such as a timer,or connected to a circuit that is regularly switched on and off by utility.
Important instructions for safety and environment Damaged mains cable should be changed notifying the Authorized Service. If the dryer is faulty, it must not be operated unless it is repaired by an authorized service agent! There is the risk of electric shock! 1.1.2 Product safety Superheating of the clothes inside of the dryer can occur if you cancel the programme or in the event...
Page 7
Important instructions for safety and environment Below specified laundry or items must not be dried in the dryer due to the fire hazard: • Garments or pillows bolstered with rubber foam (latex foam), shower bonnets, water resistant textiles, materials with rubber reinforcement and rubber foam pads.
Important instructions for safety and environment • Never attempt to repair the dryer by yourself. Do not perform any repair or replacement procedures on the product even if you know or have the ability to perform the required procedure unless it is clearly suggested in the operating instructions or the published service manual.
Important instructions for safety and environment Installation Table for Washing Machine and Dryer Washing Machine Depth Dryer Depth 62 cm 60 cm 54 cm 50 cm 49 cm 45 cm 40 cm Can be 54 cm Can be installed installed Cannot be installed Cannot be...
Important instructions for safety and environment 1.5 Compliance with the WEEE regulation and disposing of the waste product This product complies with EU WEEE Directive (2012/19/EU). This product bears a classification symbol for waste electrical and electronic equipment (WEEE). This product has been manufactured with high quality parts and materials which can be reused and are suitable for recycling.
Important instructions for safety and environment 1.8 Technical Specifications Height (Min. / Max.) 84,6 cm / 86,6 cm* Width 59,5 cm Depth 54 cm Capacity (max.) 7 kg** Net weight (plastic front door 46,5 kg usage) Net weight (glass front door usage) 48,5 kg Voltage Rated power input...
Your Dryer 2.1 Overview 1. Top panel 2. Control panel 3. Loading door 4. Kick plate opening button 5. Ventilation grids 6. Adjustable legs 7. Kick plate 8. Type label 9. Lint filter 10. Water tank drawer 11. Power cord Dryer / User Manual 12 / EN...
Your Dryer 2.2 Package Contents 1. Water drain hose * 2. Filter drawer spare sponge* 3. User Manual 4. Drying basket* 5. Drying basket user manual* *It can be supplied with your machine depending on its model. Dryer / User Manual 13 / EN...
Installation Before the calling the nearest Authorized • Your dryer can be operated at Service for the installation of the dryer, temperatures between +5°C and +35°C. ensure that electrical installation and water If the operating conditions fall outside drain is appropriate referring to the user’s of this range, operation of the dryer manual.
Installation 3.3 Connecting to the drain 3.4 Adjusting the feet In products equipped with condenser • In order to ensure that the dryer unit, water accumulates in the water tank operates more silently and vibration- during the drying cycle. You should drain free, it must stand level and balanced accumulated water after each drying cycle.
Installation 3.7 Warnings about sounds It is normal to hear a metallic noise from the compressor sometimes during operation. Water collected during operation is pumped to water tank. It is normal to hear pumping noise during this process. 3.8 Changing the illumination lamp In case an illumination lamp is used in your laundry dryer.To change the Bulb/LED used...
Electrical Connection Make sure that you have an earthed power Do not operate without the top outlet socket rated at 13 amps (minimum). cover fitted. Risk of injury. 4.1 Attention! When installed, the socket must be reachable Important after installation, or a separate switch (which can disconnect the two poles) must be used 4.3 Fitting a different plug in the installation.
Preparation 5.1 Laundry suitable for drying in the dryer Always obey the instructions given on the garment tags. Dry only the laundry having a label stating that they are suitable for drying in a dryer and make sure that you select the appropriate programme.
Preparation • Do not add wet laundry while the dryer is Following weights are given as examples. in operation Approximate Laundry • Clean the lint filter before or after each weights (g)* drying cycle. (See 7.1 Cleaning Lint Cotton quit covers Filter / Loading Door Inner Surface) 1500 (double)
Operating the product 6.3 Preparing the machine 6.5 Main programmes Plug in the machine The main programmes are given below based Place laundry inside the machine. on fabric type. • Cotton Press the On/Off button. 4. When your machine turns on for the first Dry durable laundry with this programme.
Page 22
Operating the product • BabyProtect Programme used for baby clothing with can be dried approval on the label. Very little dampness might remain on the shirts after the programme. It is recommended that you do not leave the shirts in the drying machine.
Operating the product 6.8 Auxiliary functions Loading door open Start/Pause led blinks when the loading door Sound warning cancel of the drying machine is open. Drying machine makes sound warnings when the programme is completed. If you don’t 6.10 End duration want sound notifications, press the “Sound You can delay the end duration of the Notification”...
Operating the product Canceling the end duration function 6.13 Changing the programme If you want to cancel the end duration after it is started setting countdown and start the programme After the machine starts running, you can right away: change the programme you selected to dry Cancel the programme by pressing your laundry with a different programme.
Operating the product Do not contact the inner surface of the drum when adding or removing laundry during a continuing programme. The drum surface is hot. 6.14 Canceling the programme If you want to cancel the programme and end the drying operation for any reason after the machine starts running, press the On/Off button.
Maintenance and cleaning Service life of product extends and • A layer can build up on the filter pores frequently experienced problems will be that can cause clogging of the filter after reduced if it is cleaned at regular intervals. using the dryer for a while.
Maintenance and cleaning 7.2 Cleaning the sensor 7.3 Draining the water tank There are dampness sensors in the dryer Dampness of the laundry is removed and that detect whether the laundry is dry or not. condensed during drying process and the To clean the sensors: water that arise accumulates in the water tank.
Maintenance and cleaning • Open the filter drawer by pressing the If the direct water draining is used red button. as an option, there is no need to empty the water tank. 7.4 Cleaning the filter drawer Lint and fiber that could not be captured by the lint filter are blocked in the filter drawer behind the kick plate.
Maintenance and cleaning 7.5 Cleaning the evaporator • Place the sponge back into its place. Clean the lint accumulated on the fins of the evaporator located behind the filter drawer with a vacuum cleaner. • Close the filter drawer as to lock the red button.
Troubleshooting Drying process takes too much time. • Pores of the lint filter are clogged. >>> Wash the lint filter with warm water. • Filter drawer is clogged. >>> Clean the sponge and the filter cloth in the filter drawer. •...
Page 32
End/Anti-creasing symbol is on. • Anti-creasing programme is activated in order to prevent laundry that has remained in the machine from creasing. >>> Turn off the dryer and take out the laundry. End symbol is on. • Programme is over. Turn off the dryer and take out the laundry. Lint Filter Cleaning symbol is on.
Service Service once the Please keep your purchase receipt or other proof of purchase in a safe place; you will manufacturers guarantee has need to have it should the product require expired. attention under guarantee. If you have purchased an extended You should also complete the details below;...
• Disclaims any liability for incidental or consequential damages. • The guarantee does not in anyway diminish your statutory or legal rights. Beko plc, Beko House, 1 Greenhill Crescent, Watford, WD18 8QU Tel: 0845 6004911 Email: service@beko.co.uk Fax: 0845 6004922...