You Cannot Beam Data; Verify The Following First; The Error Message For Insufficient Memory Space Is Displayed; When You Receive Data Via Beaming - Sony CLIE PEG-SJ22 Troubleshooting Manual

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

You cannot beam data

Verify the following first

B Verify that Beam Receive is set to On in the General Preferences
screen from Preferences.
B The IR port of both your CLIÉ handheld and the device must be facing
each other.
Always point the IR port of your CLIÉ handheld at the IR port of the Palm
®
OS PDA device.
B The distance between the two devices is not correct.
Verify that your CLIÉ handheld and the other Palm OS
between 4 to 8 inches (approximately 10 to 20 centimeters) apart, and that
the path between your CLIÉ handheld and the device must be
unobstructed. The beaming distance to other Palm OS
your computer varies depending on the compatibility between the devices.
Change the distance and then try again.
The error message for insufficient memory space is
displayed when you receive data via beaming
B To receive data via beaming, you need free memory space in your CLIÉ
handheld that is at least twice the size of the data you receive.
If the memory space is insufficient, delete any unnecessary data.
B Perform a soft reset by pressing the RESET button.
b
For details, refer to "Basic Operations of your Sony CLIÉ™ handheld: Restarting
your Sony CLIÉ™ handheld" in "Read This First (Operating Instructions)."
®
PDA devices are
®
PDA devices or to
31