Your Clié Handheld Does Not Operate Properly; You Cannot Turn On Your Clié Handheld; The Screen Is Not Displayed Although The Led Indicator Is - Sony CLIE PEG-SJ22 Troubleshooting Manual

Troubleshooting
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Your CLIÉ handheld does not operate
properly
You cannot turn on your CLIÉ handheld
B The battery power of your CLIÉ handheld has run out.
Connect your CLIÉ handheld to the AC power adapter with the plug
adapter (cradle) and turn on your CLIÉ handheld after a few minutes. If
your CLIÉ handheld turns on, keep charging it. When the battery charge is
done, perform a soft reset. (The battery charge takes approximately four
hours normally.)
B The connector of your CLIÉ handheld and the plug adapter (cradle) is
dirty.
You cannot charge your CLIÉ handheld if the connector is dirty. Try
connecting your CLIÉ handheld several times to the plug adapter (cradle)
to clean the connector.

The screen is not displayed although the LED indicator is

on
B The POWER/HOLD switch is set to the HOLD mode.
The screen will not be displayed when the HOLD mode is on. Set the
HOLD mode off. (Only models equipped with a HOLD switch.)
B Perform a soft reset by pressing the RESET button.
b
For details, refer to "Basic operations of your Sony CLIÉ™ handheld: Restarting
your Sony CLIÉ™ handheld" in "Read This First (Operating Instructions)."
Continued on next page
• • • • • • • • • • • • • • • • • • • • • • • • •
13