Wired Remote Controller - Fujitsu AU A30LBLU Series Design & Technical Manual

12-2.

WIRED REMOTE CONTROLLER

DIP SW
SWITCH POSITION
„ „
DIP SWITCH SETTING
„ „
1. Dual remote controller setting
Set the remote controller DIP switch No.2 according to the following table.

2. Memory backup setting
Set to ON to use batteries for the memory backup. If batteries are not used, all of the settings
stored in memory will be deleted if there is a power failure.

1 Can not be used. (Do not change)
2 Dual remote controller setting
3 Can not be used. (Do not change)
4 Can not be used. (Do not change)
5 Can not be used. (Do not change)
6
Front case (back side)
Do not use this DIP Switch
DIP Switch
Number
Master unit
of remote
DIP-SW No.2
controller
1 (Normal) OFF
2 (Dual) OFF
DIP-SW
No.6
OFF
ON
- (01 - 30) -
Memory backup setting
OFF ON
1
2
3
4
5
6
ON
(  Factory setting)
Slave unit
DIP-SW No.2
―
ON
(  Factory setting)
Memory backup
Invalidity
Validity